Meisi Knitting Pattern for Fingering Weight Gloves with Cable and Ribbing Details for Various Hand Sizes

Meisi

Materials:

383 meters / 419 yards of fingering weight yarn (shown in Wollmeise 100% superwash, colorway Neptun), about 100g / 3,5 OZ. 2,25 mm circular needle (or size to get the given gauge) long enough for magic loop Wasteyarn Tapestry needle

Gauge:

36 stitches and 48 rows on 10 cm / 4" in stockinette stitch. Take time to swatch because getting the correct gauge is essential for well-fitting gloves!

SizeHandcircumference
S18 cm / 7"
M19 cm/ 7,5"
L20,5cm / 8"

Notes: These gloves are knit using the ,magic loop" method, however you can use double pointed needles or two circular needles if you prefer. Just be aware that the instructions often refers to needle 1 and 2 (meaning each half of the total stitch count). Where stitch counts vary depending on the size, the following format is used: S [M, L]. At the beginning of each section (cuff, hand, fingers), the round numbers start anew at 1. Instructions between 2 asterisks need to be repeated to the end of the round. RG = Instructions for the right glove LG = Instructions for the left glove

READTHEWHOLEPATTERNBEFOREYOU STARTKNITTING!

NOTE:SEPARATECHARTSAREPROVIDED FOREACHSIZE.BESURETOUSETHECORRECTCHARTCORRESPONDINGTOTHESIZE BEINGKNIT. Julia Mueller - Page 1 -

Cuff Edge

Cast on 65 [70, 75] sts using the long tail cast-on. Separate the sts as follows: RG: 34 [34, 34] sts on needle 1, 31 [36, 41] sts on needle 2 LG: 32 [36, 40] sts on needle 1, 33 [34, 35] sts on needle 2 RG + LG: Round 1-6: Knit Round 7: \*k2, mBo, k2\*

How to make a bobble (mBo):

Row 1: kfb 3 times into the same stitch, turn work Row 2: sl1 purlwise wyif, p5, turn work Row 3: sl1 purlwise wyib, k5, turn work Row 4: sl1 purlwise wyif , p2tog, p1, p2tog, turn work Row 5: sl2 purlwise wyib, k2tog psso both slipped stitches

Round 8-13: Knit

Round 14: Fold the piece in half with knit side out so that the cast-on edge is touching the sts on your needles. Using the right needle, pick up a stitch out of the first cast-on stitch and place it on the left needle. K2tog the cast-on stitch with the live stitch next to it. Size S: Repeat until all cast-on stitches have been picked up / all live stitches have been used up. Work one m1 increase. Size M: Repeat until all cast-on stitches have been picked up / all live stitches have been used up. Size L: Repeat until all cast-on stitches have been picked up / all live stitches have been used up. Decrease one stitch at the end of the round by slipping one already knit stitch over another stitch. Cuff RG: Work Round 1 of chart 1 (Cuff) on needle 1 and \*k1tbl, p2, k1tbl\* on needle 2 till you finish the last round of the chart.

Pattern illustration

LG:

Work \*k1tbl, p2, k1tbl\* on needle 1 and chart 1 (Cuff) on needle 2 till you reach the last round of the chart. Work the last round up to stitch 27 of chart 1. Do not work the last 7 sts.

Hand:

RG: Before starting with the hand chart you have to change the beginning of the round by working 7 sts of needle 1 (k1tbl, p2, k2tbl, p2) and shifting them to needle 2. Work Chart 2 (Cable Panel) on needle 1, Chart 3 (Ribbing part 1) on the first 22 sts of needle 2, k2 [6, 10], work Chart 4 (Ribbing part 2) on the remaining 22 sts. When you've completed the last round on Chart 3 and 4,continue in stockinette stitch onneedle2 till you've finished round 29 [32, 35]. Go on working Chart 2 on needle 1. At the same time, proceed on needle 2 as follows: Round 30 [33, 36]: In this round, the sts for the thumb gusset need to be put on hold. On needle 2 transfer 21 [23, 25] sts on a piece of waste yarn, cast on 2 sts using the backward loop method and knit the remaining sts. Round 31 [34, 37]: knit all sts. Round 32 [35, 38]: ssk, knit all the remaining sts. Proceed working Chart 2 on needle 1 and stockinette st on needle 2 until you have completed round 37 [41, 44] of chart 2. Work chart 5 corresponding to your size. At the end of row 6 and in the beginning of row 7 put 15 [16, 17] sts for the pinky on waste yarn and cast on two sts as indicated in the chart. Do NOT work row 9. LG: Before starting with the hand chart you have to change the beginning of the round by slipping the last 7 sts of needle 2 (k1tbl, p2, k2tbl, p2) onto needle 1. Work chart 3 (Ribbing part 1) on the first 22 sts on needle 1, k2 [6, 10], work Chart 4 (Ribbing part 2) on the remaining sts of needle 1. Work chart 2 (cable panel) on needle 2. When you've completed the last round on Chart 3 and 4, continue in stockinette stitch on needle 1 till you've finished round 29 [32, 35]. Go on working Chart 2 on needle 2. At the same time, proceed on needle 1 as follows: Round 30 [33, 36]: In this round the sts for the thumb gusset need to be put on hold. On needle 1 k25 [27, 29], then transfer 21 [23, 25] sts on a piece of waste yarn, cast on 2 sts using the backward loop method. Round 31 [34, 37]: knit all sts. Round 32 [35, 38]: k 25 [27, 29], ssk. Proceed working stockinette st on needle 1 and chart 2 on needle 2 until you have completed round 37 [41, 44] of chart 2. Work chart 6 corresponding to your size. At the end of row 6 and in the beginning of row 7 put 15 [16, 17] sts for the pinky on waste yarn and cast on two sts as indicated in the chart. Do NOT work round 9.

Fingers:

The last round on the charts 5 and 6 indicates which stitches will end up being which finger and mustn't be worked. Yellow: ring finger Red: middle finger Blue: index finger The pinky isn't included as the stitches have already been transferred onto waste yarn. Transfer all sts onto waste yarn (or spare circular needle in the same size you're using or smaller) RG: Ring finger: Put 6 [7, 8] stitches from the back of the hand back on needle 1 and 11 stitches from the palm side back on needle 2. Knit the stitches from the back of the hand, cast on 2 stitches using the backward loop method and complete the round by knitting the stitches from the palm side. Continue working these 19 [20, 21] sts in stockinette stitch until the finger is 3 mm shorter than your ring finger when wearing the glove. Work k2tog to the end of the round (if the total stitchcount is uneven: knit the remaining stitch). Break the yarn and thread it through the remaining stitches twice. Pull tight and weave in theend. Middle finger: Put 8 stitches from the back of the hand back on needle 1 and 8 [9, 10] stitches from the palm side back on needle 2. Knit the stitches from the back of the hand, cast on 2 stitches using the backward loop method, knit the stitches from the palm and pick up two stitches from the cast on edge to the ring finger. Continue working these 20 [21,22] sts as described for the ring finger.

Index finger:

Put the remaining 20 [21,22] stitches back on the needle. Knit them/work the estabilshed cable pattern (see Chart 2, red box), then pick up 2 stitches from the cast on edge of the middle finger. Continue working these 22 [23, 24] sts as described for the ring finger.

Pinky:

Put the 15 [16,17] stitches which have been on hold back on the needle, distributing them on needle 1 and 2. Work the stitches on needle 1, pick up 2 stitches from the cast on edge to the ring finger, then work the remaining stitches on needle 2, maintaining the established cable pattern (see Chart 2, red box). Continue working these 17 [18, 19] sts as described for the ring finger.

LG:

Put 9 [9, 9] stitches from the palm back on needle 1 and 8 [9, 10] stitches from the back of the hand back on needle 2. Knit the stitches from the palm, cast on 2 stitches using the backward loop method and complete the round by knitting the stitches from the back of the hand. Continue working these 19 [20, 21] sts as described for the ringfinger.

Middle finger:

Put 8 [9,10] stitches from the palm back on needle 1 and 8 [8, 8] stitches from the back of the hand back on needle 2. Knit the stitches from the palm, cast on 2 stitches using the backward loop method, knit the stitches from the back of the hand and pick up two stitches from the cast on edge to the ring finger. Continue working these 20 [21,22] sts as described for the RG ring finger. Index finger: Same as on the right hand. Pinky: Same as for the right hand. Move the 21 [23, 25] sts back on your needles. The beginning of the round is placed two stitches to the left from the cast on gap. If unsure about the placement, look at the first line of chart 7. Rejoin the yarn and work chart 7 corresponding to your size until the finger is 3mm shorter than your thumb when wearing the glove. Continue as described for the ring finger. Weave in all ends. If there are any holes from where the stitches are picked up, close them by weaving in while wearing the glove.

Pattern illustration

Symbols

Description
knit
knit through the back loop
und
no stitch
Pick up stitches from the cast on edge
vPick up one stitch in the gap between the cast on edge and the stitches which were on waste yarn. Work through the back loop to preventholes
Knit two stitches together as if they were a single stitch
Slip one stitch, then slip the next. Insert left needle into the front loops of the slipped stitches and knit them together from this position through the back loops
Cast on stitches using backward loop method

Description
MMake one by lifting strand in between stitch just worked and the next stitch, knit into back of this thread
Make one by lifting strand in between stitch just worked and the next stitch, purl into backof this thread
Slip one to cable needle, hold in front, k1 tbl, k1 tbl from cable needle
Slip one to cable needle, hold in back, k1 tbl,k1 tbl from cableneedle
Slip one to cable needle, hold in front, p1, k1tblfromcableneedle
KSlip one to cable needle, hold in back, k1 tbl, p1 from cable needle
Blackhorizontal Lines indicate stitches which need toget transferred ontowaste yarn (as necessary for the thumb and the
pinky in the charts). In the given example: The first round (normal knit symbols) are worked as usual. On the second round you thread 5 sts on waste yarn.

Chart 1 (Cuff)

Pattern illustration

The red box marks the repeat section for the cable columns. Size S: leave out the green and yellow columns and stop after round 37. Size M: leave out the yellow columns and stop arter round 41. Size L: work all the columns and all rounds.

Pattern illustration

Chart 4 (Ribbing Part 2)

Chart 3 (Ribbing Part 1)

Pattern illustration

( pueh ubit) s u

B BBB A58 65 63 706968676665B
AB B B B B BBB B B B B
B
Chart 5 (Right Hand, M)B
BB B B
B BB 8BB
B B

(1 'pueh 1ub!a) s ueuo BBBBB BBBBBB B入·B日BBBBBB ··BBBBBB 口BB BBBBBBBB BB 日日<·· ·· BB BBBBBBBB ·BBBBBBBB ( h h) 9

B
m 4
5 7
co 9 10 11 12 13
4
15 16 7
18 19
2 21
26B BBBBBB
313029 32BB B BB BB BB B B B B
E SE 9E2E8EB B BBBBBBBBB BB B B
14039 41 42 43 44 45 46 47 48
49 5150 25 55B B
B
5 95
20
5B B
85B
65B
626160
B B
B B
B
3B
B
64
B
65
9
B
B
67B
6 69B B BB B B B B B

987654321 BBBBBBB BBBBBB BB BB

Chart 7 (Thumb size S)

2524 23222120191817161514131211109co764m21
4
2
++1

Chart 7 (Thumb size M)

z2262524EZ22212019181716151413121110876.U21
4
3
++2
1

Chart 7 (Thumb size L)

Pattern illustration

Please note: This pattern is for personal use only. Any commercial use is strictly prohibited. If you have any questions, suggestions or corrections, please get in contact with me (Larisknit@gmx.de / Laris on Ravelry)

Similar Design Patterns