Vetrarbraut
Originally made to fit a a smart phone, but will fit any phone around size 110 mm x 60 mm x 12 mm.
Materials:
Stitch glossary:
- 50 meters Tuva Helarsgarn or any other DK/8 ply cotton blend yarn. - 3mm dpns - A ribbon (30 cm length) sts = stitches yo = yarn over k2tog = knit to stitches together cable4 = put next 2 sts on stitch holder and hold in front of work, knit 2 sts, knit the 2 sts from the stitch holder Gauge: 4 sts knit are 2,5 cm The cover has a lot of negative ease because it grows when used. If you wanter bigger or smaller cover, just go up or down needle size.
Directions:
The pattern is a repeat of 5 rounds. Cast on 24 stitches using long-tail cast on and connect in to the round. Round 1: knit 2 sts, purl 2 sts, cable4, purl 2 sts, knit 4 sts, purl 2 sts, cable4, purl 2 sts, knit 2 sts. Round 2 - 5: knit 2 sts, purl 2 sts, knit 4 sts, purl 2 sts, knit 4 sts, purl 2 sts, knit 4 sts, purl 2 sts, knit 2 sts. Repeat rounds 1 - 5 a total of 8 times. Then knit one round as round 1 (to make cables) Next round: \*knit 1, yo, k2tog\* Repeat from \* to \* until end of round. Knit one round. Cast off: purl 2 sts, \*slip both sts back to left needle, purl 2 sts together, purl 1 stitch\*. Repeat from \* to \* until last stitch. Cut yarn, pull through last stitch, weave in the end.
Whip stitch the bottom of work flat with cables meeting each other (the cast on edge) and pull the ribbon through the loops at the top of work.
