Take a Bow Hat
This slouchy baby i beautiful, deliciously soft, super easy to knit and require only one skein of yarn. You bave to knit it. Now!
You need:
One skein of gepard Puno (110m/50g) Needles sized 4,5 mm (circular or dpns) Darning needle for weaving in ends Go for it!
Here is low you do it
Hat
CO 80 st Join to work in the round, being careful not to twist. Knit twisted rib (k1 though back loop, purl) for approximately 5 cm. Continue to knit in stockinette stitch until work measures approximately 23 cm. Begin decreasing as follows: Round 1: \*k7, k2tog. Repeat from \* to end (80 st) Round 2: Knit Round 3: \*k6, k2tog. Repeat from \* to end (70 st) Round 4: Knit Round 5: \*k5, k2tog. Repeat from \* to end (60 st) Round 6: k2tog across all stitches (30 st) Round 7: k2tog across all stitches (15 st) Break yarn, leaving a long tail to draw through remaining stitches. Weave in loose ends.
Bow
CO 8 st Knit stockinette stitch back and forth until work measures 14-15 cm. BO leaving a long tail to attach the bow to the hat. Weave in the other end. Sew the stripe's ends together to form ring, Hatten it, then scrunch it together in the middle to make it bow-like. Attach the bow to the hat as shown in the picture.
All done, enjoy!
This hat was designed by me, Therese Sharp. I blog in swedish on www.thepas.se and tweet in swedish at @ThepasSharp. I hope you liked this pattern, you are free to use it however you please with the exception of claiming it as your own. Feel free to contact me on Ravelry for questions: MrsSharp.
