Rudy Got Sole
Men's Sock Pattern By Amy Klimt http://spinalcat.blogspot.com spinalcat@gmail.com
Send your favorite rude boy off to work in these subtly checkered socks knit from the top down with a heel flap. Finished Size: $9^{\prime\prime}$ foot circumference and ${\bf10\Sigma^{1/2^{\prime\prime}}}$ long (customizable) from heel to toe. To fit men's US shoe size $^{10\ 1/2}$ Yarn: Knit Picks Risata ( $42\%$ cotton, $39\%$ superwash merino, $13\%$ polyamide, $6\%$ elastic; 196 yd/50g): ash, 3 balls. Needles: Size 1.5 (2.50mm) or size necessary to obtain correct gauge: one $32"$ circular needle (for magic loop), or appropriate needles (dpns, 2 circs, etc.) for your favorite method. Gauge: 17 sts and 25 rounds $\r=\,2^{\prime\prime}$ in stockinette stitch, 17 sts and 32 rows $\r=\,2^{\prime\prime}$ in garter check pattern. Notions: Tapestry needle, 3 small stitch markers.
Directions:
Loosely Co 80 sts using long-tail cast on (or your preferred method for socks). Place marker and join without twisting to work in the round. Cuff Work K3 P2 rib as follows for 1 1/2" (or desired length) P1 $\ast\mathsf{K}3$ P2\* K3 P1 (repeat between \* 15 times) Leg Work garter check pattern (from Barbara Walker's 1st Treasury of Knitting Stitches) as follows: Rds 1, 3, 5,7, 9, 11: knit even Rds 2, 4, 6: $\ast\mathsf{k}\mathsf{5}$ ${\mathsf p}{\mathsf{5}}^{\ast}\ {\mathsf{8}}$ times Rds 8, 10, 12: $\ast_{\mathsf{p5}}$ $k5*$ 8 times Pattern chartBlank $=$ knit $\ensuremath{\mathbf{u}}_{-}\ensuremath{\mathbf{u}}_{}=\mathsf{p u r l}$
Repeat these 12 rounds until sock measures 6 1/4" from cast-on edge (about 6 repeats), ending with round 12. If you desire a longer leg, work more repeats. Set aside the beginning-of-round marker for later. Set Up Heel Flap Heel is worked on 39 stitches. Stitches will be rearranged to set up a centered pattern on the instep. Set aside the beginning-of-round marker for later. For clarity, instep needle is labeled #1 and heel needle is labeled #2 although they are opposite ends of the same circular needle. Unknit 3 stitches from the last leg round (or if you're peeking ahead, just stop working the leg 3 stitches before the end of round) and then shift those 3 stitches clockwise from heel flap needle (#2) to instep needle (#1). Shift 2 stitches clockwise from instep needle (#1) to heel flap needle (#2). This will result in 39 heel flap stitches, beginning and ending with K2. There should be 41 instep stitches, beginning and ending with K3, which will be left on the cable for later. Turn to start working heel flap on wS row. Work Heel Flap Eye of partridge heel flap with 3 st garter edging: 4 row repeat Rows 1,3 (WS): K3, P to end RoW 2 (RS): P3, $\ast\mathsf{K}1$ $S1^{*}$ , K4 (Repeat between \*) Row 4 (RS): P3, \*S1, K1\*, K2 (Repeat between \*) Work these 4 rows 10 times $=40$ heel flap rows (20 garter ridges) Turn heel Row 1 (WS): S1, P20, P2tog, P1, turn Row 2 (RS): S1, K4, ssk, K1, turn Row 3 (WS): S1, P5, P2tog, P1, turn Row 4 (RS): S1, K6, ssk, K1, turn Continue in this manner, working one additional stitch before decreasing on every row. (next rows will contain P7, K8, etc.) The last two rows will be as follows: (note that there is no stitch worked before decreasing and turning) WS: S1, P19, P2tog, turnRS: S1, K19, ssk 21 heel st remain. Work Gusset Note: I use the method Charlene Schurch describes in Sensational Knitted Socks for picking up 2 extra stitches to avoid holes at the top of each gusset. There is a diagram in the online errata at
http://www.martingale-pub.com/Information/Corrections/B687_cor.htm PU 20 sts from first side of gusset. PU 2 extra sts at top of gusset. PM before first instep stitch. Work instep in pattern. PM after last instep stitch. PU 2 extra stitches at top of gusset. PU 20 sts from remaining side of gusset. K first 10 sts of heel, PM to indicate center of heel (new beginning of round). Decreasing extra gusset stitches: K to 2 sts before marker at beginning of instep, SSK, SM Continue established garter check pattern on instep, SM, K2tog K to end of round (marker at heel). Begin regular gusset decreases: Round 1: Kto 3 before marker, K2tog, K1, SM. Work instep in pattern. SM, K1, SSK, K to end of round. Round 2: K to marker, SM, work instep in pattern, SM, K to end of round. Repeat rounds 1 and 2 until 80 sts remain. Foot Continue working garter check pattern on instep and stockinette on bottom of foot until the measurement from heel to end of foot is 8 $1/2"$ (or $2"$ shorter than total desired foot length), ending with row 6 or 12 of instep pattern. Toe Round 1: K to 3 sts before marker, K2tog, K1. SM, K1, ssk, K to 3 sts before marker, K2tog, K1 SM, K1, ssk, K to end of round. Round 2: K all sts. Repeat rounds 1 and 2 until 40 sts remain. Then repeat row 1 only until 20 sts remain.
K5, rearrange sts so 10 sts are on each of 2 needles (1 formerly instep st will be moved to the needle with the sole sts). Finishing Cut yarn, leaving a $\mathbf{1}2^{\prime\prime}$ tail. Thread yarn on tapestry needle and graft using Kitchener stitch. Weave in ends. Dampen and lay flat to block, if desired. Work second sock following same instructions. Revision 10/26/07: Fixed cuff directions. $\circledcirc$ Amy Klimt, October 2007. This pattern is for personal and noncommercial use only.
