
The Devine Ms. M
By Moira Engel / Thebackloop on Ravelry
Materials:
Size 5mm needles straight needles Darning needle Stitch Markers 3 Skeins Lion Brand Wool Ease / Grey Heather 80% Acrylic, 20% Wool / 197 yds., 85 grams. Gauge: 5 stitches / 1 inch
Stitch Guide:
SK2PO: Sl1, K2tog, psso K1B (Knit 1 below): insert needle into stitch below the next stitch on the left-hand needle and knit it in the usual way, slipping the stitch above off the needle at the same time
Border Lace:
Cast on 15 Stitches Row 1: (WS)Purl. row 2: (RS) Sl 1, k2, yo, (k2tog, yo) twice, k3, yo, k2tog, (yo)twice, k3. (18 sts Row 3: K4, p11, yo, k2tog, k1. Row 10: Sl1, k2, yo, k3tog, yo, k2tog, yo, k1, SK2PO, k1, yo, k3tog, (yo)twice, k2, (yo)3 times, k2.(22sts.) Row 11: k2 [p1,k1,p1 in the 3 yarn overs from previous row], k3, p11, yo, k2tog, k1. Row 12: Sl 1, k2, yo, k3tog, yo, k2tog, yo, S2KPO, yo, k3tog, (yo)twice, k2tog, k6. (20 sts.) Row 13: Bind off 5, k2, p9, yo, k2tog, k1. (15 sts.) Repeat Rows 2 through 13 for pattern.
Bee Stitch:
Row 1: (WS) Knit. Row 2: (RS) K1 \*k1B, k1 repeat from \* to end. Row 3: Knit. Row 4: K2, k1B, \*k1,k1B repeat from \* to last 2 stitches, k2 Repeat these 4 rows. Instructions: This was designed as a “portable project" so each section is worked separately then seamed together. Cast on 15 stitches for "Border Lace" and work until piece measures approximately 34 inches. Binding off on row 13. Cast on 15 stitches and work “Border Lace" to match the first “Border Lace" piece exactly. Bind off. Cast on 37 stitches and work approximately 34 inches of “Bee Stitch" so the length exactly matches the first two sections of "Border Lace". Lay out finished sections with “Bee Stitch" section in the centre and one “Border Lace" section on either side. The smooth edges of the “Border Lace" should be aligned with the “Bee Stitch" section and the points should be facing out. When the sections are seamed together, position the ends together and seam. This will make a "cylinder" shape that will fit around the neck and can be pulled over the head. Fasten in all ends.